My local surface design group met yesterday and we played with soy wax. I took fabrics that were previously dyed either naturally or with Procion dyes. I did have some white fabric but didn’t use much of it.

Here’s our wax set up and we used stamps, brushes and stencils to apply the wax. You can use almost anything to apply the wax so cardboard tubes, plastic bits from packaging, foam tubes and kitchen utensils were also used to apply the wax to the fabric.

Here’s Bunny using a stamp to apply wax to her fabric.

This slideshow requires JavaScript.

These are a few of my fabrics after they were stamped with wax. You can see that the fabrics are not very exciting. Most were ones that I had dyed naturally and weren’t very exciting. After the wax hardens, then you paint fabric paint over the surface. I used Dye-na-Flow paint. I did try walnut ink but it didn’t hold after washing so that piece didn’t work out.

This is a shot of some of our work drying. Carole”s pieces are on the left. I also tried a few sketchbook pages which are on the far right.

This is a piece that Bunny did on silk. It reacted quite strangely to the wax so it will be interesting to see what the end result may be.

This slideshow requires JavaScript.

This slide show is of my finished pieces. After the paint is dry, I ironed the pieces between pieces of newspaper to melt most of the soy was away. Then I put them all in the washing machine with a hot water wash and laundry detergent. I then ironed the pieces again. This process is easier than traditional batik because the soy wax melts at a lower temperature and comes out of the fabric more easily. It was a fun afternoon and now I just need to decide what to do with my new batik fabric.